Mural And Paint Epoxy Flake Calculator

🧮 Epoxy Flake Coverage Calculator

Plan your DIY project with confidence. 😊
Enter your measurements below and we'll estimate how much material you'll need.
Planning your DIY project?
Don't worry if you're not sure about the calculation — just enter your measurements and we'll work it out for you.

1️⃣ What are you coating?

Choose the option that best matches your project.

2️⃣ What's your existing surface?

💡 Good to know: Concrete and cement surfaces can be more porous and may require more primer. Tile surfaces generally allow better primer coverage.

2️⃣ Tell us your total area

Already measured your project? Great! Just enter your total coating area.

2️⃣ Let's measure your floor 📏

ft is selected by default. You can change the unit if needed. We'll convert it for you.
💡 Tip: Just enter your measurements in ft by default. You can change the unit if needed.

3️⃣ How much of your toilet would you like to transform? 🚿

Choose how high you'd like the coating to continue up the wall.
Almost there! 😊 Just add the wall coating height so we can calculate it for you.
Almost there! 😊 Just add the wall height so we can calculate the full wall area for you.

3️⃣ Let's measure your exterior area 🧱

Almost there! 😊 Just add the wall width and height so we can calculate it for you.
📏 How to measure your pillar
Measure the width, depth and height of the pillar. We'll calculate all four sides for you.
WIDTH
HEIGHT
DEPTH
💡 Simple tip Width = left to right Depth = front to back Height = floor to the top of the pillar

If your pillar is square, simply enter the same measurement for Width and Depth.
Almost there! 😊 Just add the pillar width, depth, height and quantity so we can calculate it for you.

4️⃣ Would you like a more seamless finish?

If you're coating over existing tile, filling the tile joints first can help create a smoother, more seamless-looking surface — on the floor or wall.
💡 Quick Dry Filler coverage: 500g covers approximately 50 sqft for newly installed tile with standard joints. Older tile with deeper or wider joints may require more filler.

5️⃣ Choose your protective top coat ✨

Not sure which one? No worries — we'll help you choose.
💡 Both 2K Polyurethane and 2K Polyaspartic are suitable for indoor & outdoor applications and provide a durable, hard-wearing protective finish.

Not sure which one is right for your project?
The most suitable top coat can depend on your application experience, surface condition, project usage and required finish. Elaine can help confirm the right system for you.

6️⃣ Would you like a 2nd polyurethane finish coat?

The first coat is the Lock Coat. A second coat is the Finish Coat.
💡 For garage or drive-on areas: A second polyurethane coat may be recommended for additional drive-on durability. The final system can also depend on application experience, surface condition and project requirements.

🎉 You're almost ready!

Here's your estimated material list based on the measurements you entered.
📦 Your Estimated Materials
⚠️ A little note 😊

This is a rough calculation with a 3% material allowance for normal application loss.

Actual usage may vary depending on your surface condition, porosity, selected flake series, colour and application method.
💡 Want to use your materials more efficiently?

Before ordering, send your calculation to Elaine. We can help review your project and recommend the most suitable quantity and system.
💬 SEND CALCULATION TO ELAINE 🛒 ORDER ON SHOPEE
Place your order according to the nearest required set. Not sure which set to choose? Send your calculation to Elaine.